7) Working through the hole from the inside, align the base unit from above with the timber collar. Drill through the pre-drilled holes in the base unit through the roof and colllar using a 6mm drill bit (it is best to “G” clamp this in position). After drilling all of the holes (twelve off), remove the clamps and bring the base unit back into the building. TIP: Use 7mm to widen and give clearance for the bolts through the wood only
8) Re-assemble the lid to the base unit and remove the protective tape from the foam sealing gasket arround the base. Clean any loose material from the felt and base unit and pass the re-assembled vent through the opening and place in position. (On steep pitched roofs secure with ‘G’ clamps.)
Open the roof vent (securing with the stay to allow unobstructed access) slide all washers back into place before inserting the 6mm stainless steel bolts through the frame, roof and timber collar.
9) Fit washers and nuts from the underside and lightly tighten. Working clockwise and starting from the centre of the top, begin to tighten the nuts. (It is best to go around several times to ensure an even compression of the sealing foam).
When correct compression is achieved, a deviation will be noticed in the base unit and around the bolt heads/washers in the timber collar, this is to be expected and has been designed to give the correct compression.
For more fitting instructions check out the other pages "Felt shingles" "Insulated or Clad Roofs"
6mm, 7mm & 8mm drill bits
2 x 10mm spanner
The roof vent should only be washed using a sponge with plenty of clean water to avoid scratching.
Caustic detergents and solvents may damage the acrylic and your felt roof.
Important: We cannot be held responsible for incorrect fitting, handling or operation.
Damage occuring from incorrect fitting may invalidate your guarantee.